Stats

Locked Locked
Replies 4
Subscribers 168
Views 17527
Members are here 0

.drl file generation reg.

sreebabu1992 over 13 years ago

when generating NC drill file 'm getting the bellow error.

WARNING: Design precision is greater than that of the drill output file data.

Data rounding errors are very possible.

ERROR: The number of integer places specified for the

drill output data is not enough for this design.

Parents

girish over 13 years ago

Check setup design parameters--->design ->accuracy.
If the board unit is in mils set value as 2 & if it is mm set to 4 & In NC parameters FORMAT 5 ,5 then try generating drill file

Regards,
Girish
Cancel
Vote Up 0 Vote Down

Cancel

Reply

girish over 13 years ago

Check setup design parameters--->design ->accuracy.
If the board unit is in mils set value as 2 & if it is mm set to 4 & In NC parameters FORMAT 5 ,5 then try generating drill file

Regards,
Girish
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.