Stats

  • Locked Locked
  • Replies 7
  • Subscribers 165
  • Views 15016
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Stability analysis of an ECU by using PSPICE

madhuraj

Hi,

I am doing the stability analysis (need to look at the amplitude response, phase response and phase delay) of an electronic circuit which will drive a DC motor (ofcourse its a closed loop system). The input to the circuit varies from +10 V to -10V and circuit contain opamp ELH0041. I am using ORCAD PSPICE for the modeling and would like to know, what kind of source model I can use for this analysis and what kind of analysis I should select from PSPICE.

Any inputs on this will be highly appreciated

regards

MAdhu

 

Parents
  • Alok Tripathi

    You should perform AC analysis and make sure your input voltage source has "AC" property and it's value is set = 1. This analysis will enable you to analyze circuit response in frequency domain. You can observe gain & phase at desired output node in per unit terms. You may need to replace complex sub circuit models (if used in circuit) by equivalent small signal model for successful AC analysis. In short - this would give you bode plot at point of interest in you circuit. One can configure a circuit to be open loop or close loop.

     

     

Reply
  • Alok Tripathi

    You should perform AC analysis and make sure your input voltage source has "AC" property and it's value is set = 1. This analysis will enable you to analyze circuit response in frequency domain. You can observe gain & phase at desired output node in per unit terms. You may need to replace complex sub circuit models (if used in circuit) by equivalent small signal model for successful AC analysis. In short - this would give you bode plot at point of interest in you circuit. One can configure a circuit to be open loop or close loop.

     

     

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.