Stats

  • Locked Locked
  • Replies 2
  • Subscribers 165
  • Views 2562
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Add positioning hole to symbol - Allegro/PCB Editor

TAyres

Hi all,

I'm creating a footprint for a Camera Link connector (26 pin 3M MDR connector); I need to add some mounting and positioning holes. Should I define them as 'pins' and leave them as unplated drill holes? I'm sure there's a better way.

Thanks,

-Travis 

Parents
  • TAyres
    It looks like I need an UNSPEC pin, then to define the top copper layer for the lockstand solder pad outline. I'm trying to see how to do that, but have thus far failed. 
Reply
  • TAyres
    It looks like I need an UNSPEC pin, then to define the top copper layer for the lockstand solder pad outline. I'm trying to see how to do that, but have thus far failed. 
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.