Stats

  • Locked Locked
  • Replies 7
  • Subscribers 165
  • Views 14766
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

wiring on a defined plane ***help***

pitbull107

 OK, I know I've done this before, but I don't remember the setup:

I want to have a dynamic plane (like VCC) to contain wiring of other nets. So, when I start the wiring, the "shape" will create the "shape to line spacing" I setup in constraint manager.   (kinda like auto voiding)

Right now, I am getting drc errors and the "voiding" is not happening even though the drc says the contsraint should be 10 mil, I am getting 0 mil

Parents
  • steve

    Is the shape you've drawn dynamic or static ? If it's static it will not auto void and tracks you draw. Try Shape - Change shape type, then look to the Options menu and make sure the type is set to Dynamic copper then lmb the shape.

Reply
  • steve

    Is the shape you've drawn dynamic or static ? If it's static it will not auto void and tracks you draw. Try Shape - Change shape type, then look to the Options menu and make sure the type is set to Dynamic copper then lmb the shape.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.