Stats

  • Locked Locked
  • Replies 5
  • Subscribers 164
  • Views 14529
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem placing multi-part schematic symbol in Allegro Design Entry

mvonahnen

 I just built a new schematic symbol using the spreadsheet entry method.  It has 9 sections (Heterogeneous) and I can place sections B through I with no problem.  When I attempt to place section A, I instead get one of the other sections (usually the one after the last one I placed).

 Any idea what is causing this?

Parents
  • chads108

     You shouldn't have to do "stupid tool tricks".  Something obviously went wrong in the creation of the part from the spreadsheet.  You should be able to place any section at will.

    Chad 

Reply
  • chads108

     You shouldn't have to do "stupid tool tricks".  Something obviously went wrong in the creation of the part from the spreadsheet.  You should be able to place any section at will.

    Chad 

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.