Stats

  • Locked Locked
  • Replies 4
  • Subscribers 165
  • Views 13865
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cross-Probing

Yoda5939

All, 

I have been trying to get cross probing to work with less than favorable results. I have AppNote from EMA and have been exchanging posts with the AE. In a previous life, I had cross-probing working just fine. I followed alll the instructions but it seems the system is mute. I selected ICT in Capture CIS and made sure I ran a new netlist and set OrCAD  PCB Designer in highlight mode. No go. I then placed the schematic and layout in a folder on the C drive because the AE says it has a hard time across networks. No go. The last thing is the AE has no problems with the files I sent, I'd like to get this thing going for my user's sake. I don't really use it but now that's known it exists I should be able to offer cross probing to my clients/colleagues. Any help will be apppreiciated.

-Ron Scott 

Parents
  • fxffxf

     Did you try installing the latest OrCAD pataches?

Reply
  • fxffxf

     Did you try installing the latest OrCAD pataches?

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.