Stats

  • Locked Locked
  • Replies 3
  • Subscribers 165
  • Views 13280
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

After editing the schematic part, the symbols are not get updated in board?

Dhamodharann

I had placed the component, then for the routing convenient the part pin has been swapped in schematic. After the swapping of pins i had updated the net list option. In that what option should i gave to board option.? In case i m try to update the net list means, net list fails The image is been below. Any solution for the problem occurs.

 

Parents
  • Steve i had done a mistake on import the logic on File-----> Import-----> logic----> . In this The directory has been target ed some other folder too. that make an problem.Now the schematic is get updated with the changed made in respective schematic is working.
Reply
  • Steve i had done a mistake on import the logic on File-----> Import-----> logic----> . In this The directory has been target ed some other folder too. that make an problem.Now the schematic is get updated with the changed made in respective schematic is working.
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.