Stats

  • Locked Locked
  • Replies 4
  • Subscribers 165
  • Views 13786
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

X over pad in PCB editor

zquinn3

 Hi Guys,

I've only been using ORCAD for about 2 months now, so I'm sure this is a silly problem. I seem to have an issue with one of my nets - I am getting an "x" over all of the pads in the net and not a single component appears to get associate with that net. I have attached a screenshot of a portion of my schematic and layout, and can attach more/provide more information if needed.

 

Thanks, 

 

Parents
  • zquinn3

     Ah, you're onto something there! Yes, this used to be a 4 layer PCB with a plane for that net. But now I have deleted that plane. Any idea how to get the software to recognize that plane is gone and the net must now land on the top/bottom layer?

Reply
  • zquinn3

     Ah, you're onto something there! Yes, this used to be a 4 layer PCB with a plane for that net. But now I have deleted that plane. Any idea how to get the software to recognize that plane is gone and the net must now land on the top/bottom layer?

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.