Stats

Locked Locked
Replies 7
Subscribers 165
Views 14592
Members are here 0

Nets are not enabled during, component placement?

Hi..

When i try to place the SMD & Through hole components inside my board, the components pin nets are not get enabled, also yellow colour mark outline is also get marked on corresponding pin.

The image link is attached below:

http://s30.postimg.org/uda0iwxwh/Error_Message_42.png .

Then i had tried to update the netlist also, not succeeded . On the constraint manager also the nets not enabled.

Parents

Dhamodharann over 10 years ago

Yeah you was correct Johan.Some components are connected to the voltage line. In case i want to put routing for that components means it is possible.

Then i had updated the netlist again and again, but the nets are not enabled on the component.

I want to complete board urgently. Any possible tricks to enable the nets for routing.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Dhamodharann over 10 years ago

Yeah you was correct Johan.Some components are connected to the voltage line. In case i want to put routing for that components means it is possible.

Then i had updated the netlist again and again, but the nets are not enabled on the component.

I want to complete board urgently. Any possible tricks to enable the nets for routing.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.