Stats

  • Locked Locked
  • Replies 4
  • Subscribers 166
  • Views 17060
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Measuring Edge to Edge of a hole or pad.

Lennie

Is there a way to use measure to measure from two points selected by the current cursor location ? For example measuring the size of a pad or anti pad opening ?

Parents

  • Thank You!!

    Was wondering what I was doing wrong.  Understanding the command syntax is key.

    I was doing the snap to pad edge but then I was left clicking close to the pad edge expecting it to snap.

    So the right mouse button snap is the command execute.

Reply

  • Thank You!!

    Was wondering what I was doing wrong.  Understanding the command syntax is key.

    I was doing the snap to pad edge but then I was left clicking close to the pad edge expecting it to snap.

    So the right mouse button snap is the command execute.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.