Stats

  • Locked Locked
  • Replies 4
  • Subscribers 167
  • Views 14623
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can a cutout be added to a footprint?

pdxbtw

I'm new to PCB editor and I need to make a footprint for an RF connector that sits into a cutout on the edge of the board (and is edge plated around the cutout, ideally). I have to place more than a dozen of these connectors and I would like a way of easily moving them if I need to. Is there a way to add a cutout to a footprint so that I only have to place one object?

Parents
  • docb
    In some ways Eagle is easier for beginners, just because of the support and community. OrCAD is better if you can fight thru a bit.
Reply
  • docb
    In some ways Eagle is easier for beginners, just because of the support and community. OrCAD is better if you can fight thru a bit.
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.