Stats

  • Locked Locked
  • Replies 5
  • Subscribers 167
  • Views 17643
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Create or Update netrev failed, not updating netrev

Vikas Dabas

Hi,

i have made netlist without errors, I wants to update the netlist of board file that i'm using now. i mean it is open.

Now i select the create and update board netrev, but it it opens new board rather than updating the same board.

 i have tried do not open board file, but it is still not updating the board that is open now and in use.

Thanks.

Vikas Dabas

Parents
  • oldmouldy
    If you have the "target" board open in PCB Editor, it will have a lock file associated with it and won't be updated, check the Session Log messages. Close PCB Editor and then run the Uprev process again from Capture / CIS.
Reply
  • oldmouldy
    If you have the "target" board open in PCB Editor, it will have a lock file associated with it and won't be updated, check the Session Log messages. Close PCB Editor and then run the Uprev process again from Capture / CIS.
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.