Stats

  • Locked Locked
  • Replies 6
  • Subscribers 167
  • Views 15537
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Snake mode disable

redwire

Hi
I'm evaluating 16.6-2015 and am playing with snake mode.  I found that once I select it during a route any further routing that is not dangling won't start routing.  I get an error message in the command window saying that the line must be dangling.

Got it.  Now how do you turn it off without clicking on a dangling route?  The only method I have found is to create a dangle and then RMB->Snake off

Is there a way to kick off snake mode through another menu?

Thanks

Bill

Parents
  • steve
    Take a look at the pdf. http://www.parallel-systems.co.uk/e-mail/PCB_Suites-MATRIX.pdf It has a "New in 2015" which should give you a clue. The Performance L (which is now Allegro PCB Designer) is the third column.
Reply
  • steve
    Take a look at the pdf. http://www.parallel-systems.co.uk/e-mail/PCB_Suites-MATRIX.pdf It has a "New in 2015" which should give you a clue. The Performance L (which is now Allegro PCB Designer) is the third column.
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.