Stats

  • Locked Locked
  • Replies 4
  • Subscribers 166
  • Views 14985
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unconnected Pins Report says through hole in pad not connected to plane

jmadsenee

I am using Orcad PCB Editor V17.2.  I have a symbol for a LFCSP with an exposed pad and the pad has 4 holes in it.  On the schematic, the pad is connected to ground, and it can be clearly seen it the 3D view that the holes are indeed there and connect to the ground plane.  However, the Unconnected Pins Report shows those pads as unconnected.  Viewing the rat, I see it going from the center of the pad to a nearby ground via.  Anyone have any thoughts?


Thanks!

Parents
  • KeithP
    It does not get connected because you do not have a Regular Pad feature on the internal layers
Reply
  • KeithP
    It does not get connected because you do not have a Regular Pad feature on the internal layers
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.