Stats

  • Locked Locked
  • Replies 1
  • Subscribers 166
  • Views 547
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Allegro 16.6 "Marked Fanouts" disappear after eco process

55STRAT

All, I have capacitors, resistors fanned out and tied to symbol (MARKED) for ease of Move/Routing.

I need to change parts with same footprint. After I import Logic, the "Marked" fanouts go away.

I can "Unmark" the offending fanouts, then run and all is well. Unfortunately, this is NOT the solution we are looking for.

Any ideas would be appreciated. TIA, Patrick

Parents
  • steve
    Check the exact version you are running from Help - About. If it says 16.6 P00X then this is more than likely the base release and the cause of the problem. Get the latest hotfix from Cadence online support. The latest hotfix is S086.
Reply
  • steve
    Check the exact version you are running from Help - About. If it says 16.6 P00X then this is more than likely the base release and the cause of the problem. Get the latest hotfix from Cadence online support. The latest hotfix is S086.
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.