Stats

  • Locked Locked
  • Replies 8
  • Subscribers 166
  • Views 17198
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Synchronisation lost between Capture (schematic) and Allegro PCB (16.6)

elaa

Hello,

I am facing an issue where parts selected in the Allegro PCB editor doe not get highlighted in the schematic and vise versa.

Also, when in manual placement mode when selecting group of parts to be placed in the PCB this is not happening unlike in the past.

I have generated the netlist as usual via the netlist button and then imported in Allegro.

Please advice.

Thanks,

Nik

Parents
  • elaa
    Hi Dale,

    Thanks for your reply.

    I have tried your fix , capture was net selected, but unfortunately no change.

    I still cannot synchronise pcb and schematic, I am clicking on a component in pcb and is not highlighted in schematic.

    Any other suggestions?

    Regards,
    Nik
Reply
  • elaa
    Hi Dale,

    Thanks for your reply.

    I have tried your fix , capture was net selected, but unfortunately no change.

    I still cannot synchronise pcb and schematic, I am clicking on a component in pcb and is not highlighted in schematic.

    Any other suggestions?

    Regards,
    Nik
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.