Stats

  • Locked Locked
  • Replies 3
  • Subscribers 166
  • Views 1622
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NCroute file doesn't lineup properly with artwork and drl files

Mukil

Hi,

I tried to generate the ncroute in the manufacturing to get the details of the rectangular slots in my board design. Unfortunately when viewed in the gerber viewer it was not matching the excellon format and rectified it later though the ncroute files doesn't lineup properly with the artwork as well as the drl file.

Please give any alternate suggestions to make sure it doesn't go mismatch with the artwork.

Regards,

Mukilan P

Parents
  • steve
    It's not down to format - just make sure this matches the board data - it's down to the import into the gerber viewer. When you generate the NC Drill though always enable Auto Tool Select and Enhanced Excellon format. that may also help.
Reply
  • steve
    It's not down to format - just make sure this matches the board data - it's down to the import into the gerber viewer. When you generate the NC Drill though always enable Auto Tool Select and Enhanced Excellon format. that may also help.
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.