Stats

  • Locked Locked
  • Replies 4
  • Subscribers 165
  • Views 13835
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

library builder 17.2: how to bilid a NON-PLATED HOLE

ColinLiu

Hi friends,

Some of connectors has one or two plastic pitch pin which has not any eletrical property. it should be as NON-PLATED HOLE in PCB. But I can not find how to implement this at library builder.

All the PINS export by Library builder seems as PLATED PIN. Any method to achieve this？

Parents
  • steve

    Currently the only option you have is to edit the padstack once it's in PCB Editor and change it from a PTH type hole to a Mechanical one then set it as Non-plated. Cadence have plans to address this at the next release of Library builder though.

Reply
  • steve

    Currently the only option you have is to edit the padstack once it's in PCB Editor and change it from a PTH type hole to a Mechanical one then set it as Non-plated. Cadence have plans to address this at the next release of Library builder though.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.