Stats

Locked Locked
Replies 2
Subscribers 165
Views 1714
Members are here 0

How to restore "old" Junction behavior?

In pre 16.6 versions of OrCAD it was possible to break up a wire by placing junctions along the wire and then deleting the intermediate segment that was created. Now that behavior does not exist in the default install of OrCAD.

I did notice that there is a variable in the CAPTURE.INI file called "JunctionMode" which I suspect controls this behavior -- however I have no clue what values it can take.

Is there a way to restore the old Junction behavior (pre 16.6)?

Thanks
Bill

Parents

redwire over 8 years ago

Unfortunately that does not address the original question. Those modes do not change the behavior that used to exist.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

redwire over 8 years ago

Unfortunately that does not address the original question. Those modes do not change the behavior that used to exist.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.