Stats

  • Locked Locked
  • Replies 3
  • Subscribers 166
  • Views 13718
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PCB Land pattern with multiple shapes

Frozen001

I am trying to make a PCB land pattern for an RF shield that is mounted using special clips.

the clips are here:

https://hollandshielding.com/PCB-shield-mounting-Ultra-tiny-clip-UTC
https://hollandshielding.com/PCB-shield-mounting-Ultra-tiny-corner-clip-UTCC

I originally figured I could just create a custom symbol for the land pattern, but that does not work as you can only have one shape.  Ideally, I want a footprint that has the 4 corner clip patterns and the straight patterns all in one footprint that only has to have one pin in the schematic to ties those to ground.

Any thoughts on how to best do this?  I also need to have the keep outs in specific areas near the clips and where the shield would be near the PCB.

Parents

  • If you don't need to connect to it (and will rely on the part making contact to the three pads) you can either make these mechanical pins so you then only have one pin the schematic. You can also place one pin down in a package symbol and then draw copper shapes for the other sections. Keepout areas can be drawn in the package symbol.

Reply

  • If you don't need to connect to it (and will rely on the part making contact to the three pads) you can either make these mechanical pins so you then only have one pin the schematic. You can also place one pin down in a package symbol and then draw copper shapes for the other sections. Keepout areas can be drawn in the package symbol.

Children
  • in reply to steve

    Thanks for the input.  I think because I want them all connected to ground I may just run a small slice of copper to connect them all and call it a day.  That way it technically is "one" shape, but still has the distinct shape needed to match the recommended land pattern.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.