Stats

  • Locked Locked
  • Replies 2
  • Subscribers 166
  • Views 16185
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DRC error: route keepout spacing

masamasa

hello

i have a route keepout spacing error.

i do know that i can allow "vias", "routes" (clines), "pins" and "shapes" in the keepout shape area by changing the shape properties.

but i get this "line to keepout spacing" error as i place a text into a keepout area.

is there any way to allow a text or a line into a keepout shape area by changing the shape properties?

Parents
  • steve

    The only option I believe you have Is to manually void the text so draw a void inside the shape to clear the text.

  • masamasa
    in reply to steve

    thank you for your advice.

    based on your advice, i voided the text from the shape by exporting the text gerber out, outlining the text lines and imported the outer lines into pcb editor.

    thank you again, steve

Reply
  • masamasa
    in reply to steve

    thank you for your advice.

    based on your advice, i voided the text from the shape by exporting the text gerber out, outlining the text lines and imported the outer lines into pcb editor.

    thank you again, steve

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.