Community PCB Design & IC Packaging (Allegro X) PCB Design 10 Layer PCB project won't generate Gerber's completely...

Stats

  • Locked Locked
  • Replies 2
  • Subscribers 173
  • Views 1196
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

10 Layer PCB project won't generate Gerber's completely for middle layers

MPollock

Hello Fellow PCB Designers,

We have a 10 layer PCB design that originated in Pads and was converted over to Allegro 17.4, this is an old design but is manufacturable and works perfectly fine.  When I try to generate a Gerber for the Top or Bottom layers

the Gerber comes out fine.  But Most of the middle layers are Etch's and via's for power and grounds, but the Gerber's come mostly blank, there might be some details, but in the Gerber view everything is displayed correctly.

The design does have many close spacings, I have not changed anything in the constrains manager yet, turned off a lot of the DRC's, but thinking there might be something wrong with the constrains.

  I find that the CSet is set to 2_18, not sure yet what this means, also there are many of these definitions, PCS 3,4,5,ect, are the same as CSet 2_18 any suggestions would be great, we are currently looking into this, have seen

that even small change in constraint manager can cause long processing and even Allegro crashing, this is a large project.

Thanks Much, Thanks, Mike Pollock.

Parents Reply Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.