Stats

Locked Locked
Replies 2
Subscribers 166
Views 10727
Members are here 0

Purging duplicate vias in pcb editor

How do we purge/remove the duplicated vias in the same location of the PCB editor? These vias are not the one stacked and they are just blind vias running in internal layers 12-14. I find there is an additional copy of the blind via at the same location. Not sure what caused this issue.

steve over 3 years ago

A Database Check may/may not remove these but worth a try. If not turn on the duplicate drill holes DRC (Setup - Constraints - Modes then General) which will show a DRC where they are.
Cancel
Vote Up 0 Vote Down

Cancel
RFinley over 3 years ago

This happens all the time to people who translate to Allegro to delay confronting management over the inevitable: floating PADS out to the middle of a pond and setting fire to it.

https://community.cadence.com/cadence_technology_forums/f/pcb-skill/13232/any-way-to-identify-double-hits-via
Cancel
Vote Up 0 Vote Down

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.