Stats

  • Locked Locked
  • Replies 2
  • Subscribers 164
  • Views 13798
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

unconnected pins error

archive

After migrating the design from protel(Altium) to Allegro 15.2, "unconnected pins report" showed 380 pins unconnected.Actually the pins were connected,but the clines did not snap to the middle of the pins.By re-connecting the two pins and check the "snap to connect point" box, the problem was solved. But there are too many errors like that, re-connecting all the pins cost too much time.Is there a way to set up Allegro properly and solve the errors all-together?

Thanks in advance.

Regards,
HappySniper


Originally posted in cdnusers.org by HappySniper
Parents Reply Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.