Stats

More Content

Getting Error ORPSIM-15108 on trying to simulate my project

GR202506302211

Hello

I'm trying to simulate a circuit with Orcad Capture CIS (30 day tryal version) and the part AD8250.

I imported the AD8250 Spice model from the .cir file and created the .olb file 

I was able to place the AD8250 part but i already have this drc:

"WARNING(ORCAP-2445): Instance U4: SCHEMATIC1, PAGE1 (2.20, 4.00). not found in the configured libraries"

Then if i try to run a simulation then i have this error:

"ERROR(ORPSIM-15108): Subcircuit AD8250 used by X_U4 is undefined"

I tryed to follow the steps below without success:

Troubleshooting OrCAD Capture PSpice Simulation Flow Errors 

The AD8250.ind was generated so it should not be a write access permission issue

Any ideas to solve that ?

Parents Reply Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.