Following Cadence Design Systems’ acquisition of the Design & Engineering (D&E) business, the D&E Community Forum on the Nexus Community Center has been migrated in the Cadence Physical System Simulation Community. For more details and if you have any questions, please refer to the FAQ.

Stats

  • State Not Answered
  • Replies 7
  • Subscribers 1
  • Views 18
  • Members are here 0
More Content

Simulation of fmu model from Acar in Simulink

jozef.bucha
Hello everyone,
 
I have model of vehicle in Acar. Models works fine in Acar (no warning message,), but if i want to use it in Simulink the simulation ends with Error in supplied FMU: An error occurred in function 'fmi2ExitInitializationMode' for block.
 
How can I start to debug this and get more information about simulation run and what is wrong?
 
Produced fmu can be used without problem in Adams Realtime animation but not as fmu model in Simulink
Any recommendation about solver settings in Simulink or Adams, which could helps
 
Thanks for advices
 
Jozef
Parents
  • 0
    Hi Frieder. Yes and no. My model is working but I do not know what was source of that error. In my case problem was in rack and pinion template where is bushing between pinion and steering shaft. I have removed that bushing and made same modification. Full vehicle assembly vehicle was working without problem but generated fmu was not working.

    After this issues I remade template again from rack and pinion template where I have that bushing connecting pinion and steering shaft and full vehicle assy and generated fmu started to work.

    Jozef





    Dňa st 1. 3. 2023, 15:22 SimCompanion napísal(a):
Reply
  • 0
    Hi Frieder. Yes and no. My model is working but I do not know what was source of that error. In my case problem was in rack and pinion template where is bushing between pinion and steering shaft. I have removed that bushing and made same modification. Full vehicle assembly vehicle was working without problem but generated fmu was not working.

    After this issues I remade template again from rack and pinion template where I have that bushing connecting pinion and steering shaft and full vehicle assy and generated fmu started to work.

    Jozef





    Dňa st 1. 3. 2023, 15:22 SimCompanion napísal(a):
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.