Stats

  • Replies 4
  • Subscribers 48
  • Views 15486
  • Members are here 0

PSpice COM Wrapper error

bardeen101

Hi I am a student and new to orcad. I run into " The PSpice COM Wrapper error has occureed." everytime I try to open a .opj file. I had Orcad lite 16.5 installed on my pc in the morning, then installed 16.2 without uninstalling the first one. Then I uninstalled 16.5 lite verson followed by 16.2. Also i removed orcad entries from registry( don't know if i deleted all necessary, don't know much about it). And after reinstalling I still get the error. Any advice!

 Thank you,

Sunil

Parents
  • bardeen101

    Hi,

    I am running windows 7 (i keep it updated with windows update) on the pc which gives me aforementioned error. So I installed orcad 16.2 in window xp 64 bit PC, fresh install without any previous contamination of orcad versions,and when I open the .opj file , I get errors with netrev but it gives me netlist and opens up PCB editor and no PSpice Com wrapper error. I have been using the same .OPJ file throughout this test. So I am assuming that the mixed installation has done something to my registry.

    Thank you for your reply, please advice further.

     

Reply
  • bardeen101

    Hi,

    I am running windows 7 (i keep it updated with windows update) on the pc which gives me aforementioned error. So I installed orcad 16.2 in window xp 64 bit PC, fresh install without any previous contamination of orcad versions,and when I open the .opj file , I get errors with netrev but it gives me netlist and opens up PCB editor and no PSpice Com wrapper error. I have been using the same .OPJ file throughout this test. So I am assuming that the mixed installation has done something to my registry.

    Thank you for your reply, please advice further.

     

Children
No Data
CDNS Forum Thread CSS JS
CDNS - Fix Layout