• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Computational Fluid Dynamics

Computational Fluid Dynamics

CDNS Forum CFD Categories

AutoMesh

Flow

Installation

Marine

OpenLabs

Optimization

Fidelity Pointwise

Results analysis

Turbo

Online CFD Course

Feedback, Suggestions, and Questions

Provide feedback on the forums or any other part of the site. Questions and suggestions welcome.

  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

Forum - Thread List

Latest Posts

  • Answered

    Problem after the solver crushing in Fine Marine

    Category: Installation

    By AhmedTaha

    •

    updated over 3 years ago by AhmedTaha

    2 replies • 4808 views
  • Answered

    Discontinuity in mesh on the blade tip when tip gap is introduced

    Category: Turbo

    By Teja971201

    •

    updated over 3 years ago by domen

    3 replies • 2951 views
  • Answered

    Problems with openLabs

    Category: OpenLabs

    By sriluta

    •

    updated over 3 years ago by sriluta

    12 replies • 14089 views
  • Answered

    Check mesh blocks in turbo

    Category: Turbo

    By aescudero

    •

    updated over 3 years ago by domen

    1 replies • 1968 views
  • Answered

    Export to .msh fluent format

    Category: AutoMesh

    By Teja971201

    •

    updated over 3 years ago by Teja971201

    7 replies • 11425 views
  • Answered

    Export blade surface mesh

    Category: Turbo

    By aescudero

    •

    updated over 3 years ago by domen

    3 replies • 3448 views
  • Answered

    Recirculation near volute throat causing divergence in FineOpen

    Category: Turbo

    By JosephSmith

    •

    updated over 3 years ago by JosephSmith

    6 replies • 5724 views
  • Answered

    Export full annulus mesh in Turbo library

    Category: Turbo

    By aescudero

    •

    updated over 3 years ago by domen

    3 replies • 3027 views
  • Answered

    License check has failed

    Category: Installation

    By Torki

    •

    updated over 3 years ago by Torki

    2 replies • 8058 views
  • Answered

    M_Mesh Setup 1 Error 255: ssh error

    Category: AutoMesh

    By aescudero

    •

    updated over 3 years ago by aescudero

    2 replies • 4148 views
<>

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2026 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information