Stats

  • Locked Locked
  • Replies 6
  • Subscribers 127
  • Views 25375
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Display operating point

santoshvema
Hi, I am using CMOS 90nm technology in cadence and I just wonder how I can display the region of operation, gm, and id etc for my transistors. I tried the same steps that we used to do for cmosp18 technology in cadence but I couldn't succeed. Thanks. -Santosh
Parents
  • ECILCadence

    Hello,


    Pls check your model files..these may be hspice model. we also faced the similar problems when using hspice models but resolved it by using spectre model files.


    regards

Reply
  • ECILCadence

    Hello,


    Pls check your model files..these may be hspice model. we also faced the similar problems when using hspice models but resolved it by using spectre model files.


    regards

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.