Stats

Locked Locked
Replies 1
Subscribers 126
Views 13288
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

about the corner analysis

hi,there

I am working with IC5141 USR6 add MMSIM72.

I want to know the relationship between the configuraton in the option "Setup -> Model Library" and the scs file concluded in the PCF or DCF file loaded into the corner window.Do they have the same effect on the simulation? And if I want to run a corner analysis,should I setup the model library in the ADE,or just configure the corner analysis window instead?

Regards,

minci

Parents

Quek over 15 years ago

Hi minci

The model file settings in the corner tool will be used so the model file settings in the main ADE window do not matter.

Best regards
Quek
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Quek over 15 years ago

Hi minci

The model file settings in the corner tool will be used so the model file settings in the main ADE window do not matter.

Best regards
Quek
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.