Stats

  • Locked Locked
  • Replies 7
  • Subscribers 124
  • Views 10214
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pin names

StreamCX

 I have schematic and symbol with output/input liters like Q1, Q2, Q3....

CLK1, CLK2,

When I try plot outputs (add wires) in analyses I see net names in numeral.

How can I see pins of element in analysis output window (not in cipher, in form like Q1, Q2)?

Parents

  • If for example you're simulating a testbench for the symbol, (I think) the nets attached to the pins will not take the names of the pins, you have to label them (press l, enter the name, click on the net). If you are descend editing the symbol then trying to plot the net, it should have the name of the net so long as its attached to a pin.

Reply

  • If for example you're simulating a testbench for the symbol, (I think) the nets attached to the pins will not take the names of the pins, you have to label them (press l, enter the name, click on the net). If you are descend editing the symbol then trying to plot the net, it should have the name of the net so long as its attached to a pin.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.