Stats

  • Locked Locked
  • Replies 9
  • Subscribers 126
  • Views 18450
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

QRC + command file

Slawa

Good afternoon dear colleagues.
I had a following problem.
I have started to master QRC but I can not adjust command file in any way. In particular I can not understand with -technology_library_file and -technology_name. Constantly writes "Could not map technology name "LALA" to a path using "/./XXX"Check spelling to insure the name is correct."   I have created a separate folder "techgen" in which have made simulation Techgen -si and Techgen -compilation. In it has put ict, proc, p2lvs, lvsrule, and qrcTechFile. And here to start QRC does not leave. What it is necessary to enter in a  -technology_name and -technology_library_file ? Very much I count on your help.

Best regards

Beginner engineer from Russia

Parents

  •  Many thanks for fast and the main thing the intelligible answer. Then we will return to "library_cell_list_file". What its syntax? And if I will tell I have project PROJECT containing LOGIC1 LOGIC2 IP1 IP2 PAD1 PAD2 that "library_cell_list_file" should contain them? Or this parametre concerns what that still? And with what the similar error can be connected?

    WARNING (RCXSPIC-28051): Substrate stamping disabled for X-DSPF/SPEF.
    WARNING (RCXSPIC-28131): The SPEF language as per IEEE 1481-1999 does not have a
     syntax for printing parasitic resistor or capacitor model names
    ERROR (LBMISC-215480): at "RCXspice": LVS connectivity file  is missing .2.
    ERROR (LBRCXM-633): Bad return status from RCX script generator. Status 512
    INFO (LBRCXM-709): *****  QRC terminated abnormally  *****

    Best regards

    Beginner engineer from Russia 

Reply

  •  Many thanks for fast and the main thing the intelligible answer. Then we will return to "library_cell_list_file". What its syntax? And if I will tell I have project PROJECT containing LOGIC1 LOGIC2 IP1 IP2 PAD1 PAD2 that "library_cell_list_file" should contain them? Or this parametre concerns what that still? And with what the similar error can be connected?

    WARNING (RCXSPIC-28051): Substrate stamping disabled for X-DSPF/SPEF.
    WARNING (RCXSPIC-28131): The SPEF language as per IEEE 1481-1999 does not have a
     syntax for printing parasitic resistor or capacitor model names
    ERROR (LBMISC-215480): at "RCXspice": LVS connectivity file  is missing .2.
    ERROR (LBRCXM-633): Bad return status from RCX script generator. Status 512
    INFO (LBRCXM-709): *****  QRC terminated abnormally  *****

    Best regards

    Beginner engineer from Russia 

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.