Stats

Locked Locked
Replies 3
Subscribers 126
Views 15781
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

multi metal layers and vias

Dear All,

I am using IC5.1.41 for schematic and Vituoss XL layout for the layout drawing. The design kit that I am using is Jazz CA 18. Currently, I need to creat an array of vias (saying 12 by 10) between metal 1 and metal 5. I tried to create the via one by one and it seemed so tedious. In addition, once I made a mistake in drawing a via, I cannot even highlight the specific via and delete it. I am wondering whether there is a better way to perform it. Thanks a lot in advance.

Bests

Tester

Parents

Quek over 15 years ago

Hi Tester

Please use the contact functions from the toolbox. I think you are looking for "Contact Array" function. It allow you to create via arrays for non-adjacent metal layers.

Best regards
Quek
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Quek over 15 years ago

Hi Tester

Please use the contact functions from the toolbox. I think you are looking for "Contact Array" function. It allow you to create via arrays for non-adjacent metal layers.

Best regards
Quek
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.