Stats

  • Locked Locked
  • Replies 4
  • Subscribers 125
  • Views 18249
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

change the name of a net in virtuoso XL

tester

Dear All,

I am using ic 5.1.41 for schematic and the associated virtuoso XL for layout drawing. I have a very simple question? how do I change the name of a net?

Thanks

 

 

Parents
  • Try using menus such as Connectivity->Check->Against Source and Connectivity->Update->Components and Nets to check/update your design rather than reinitialising from scratch.

    You may just be best logging a service request via http://support.cadence.com and talking this through with an Application Engineer.

    Best Regards,

    Andrew.
Reply
  • Try using menus such as Connectivity->Check->Against Source and Connectivity->Update->Components and Nets to check/update your design rather than reinitialising from scratch.

    You may just be best logging a service request via http://support.cadence.com and talking this through with an Application Engineer.

    Best Regards,

    Andrew.
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.