Stats

  • Locked Locked
  • Replies 8
  • Subscribers 127
  • Views 18330
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

mixed signal design flow

hon cheong

Hi ,

I would like to know about the correct flow for mixed signal design. Assuming now I have all my analog blocks readily verified in spectre, and the layout of the analog blocks pass DRC and LVS check. My digital blocks ( e.g state machine) layout are obtained from the place and route tool ( Cadence encounter). If I want to verify the system which consist of both analog and digital circuits, should I stream out the digital blocks layout into Cadence Virtuoso to combine both digital and analog layout together, then run DRC and LVS again, and extract the parasitic and rerun the whole system simulation ? But I am wondering will it take me a very long time to run the simulation as the digital blocks might consist of quite a number of gates.

 I have run AMS simulation by combining the analog blocks and VHDL code together. But I am not convinced by the simulation result as the behavioral VHDL code and the analog circuits does not seems represent the actual circuit behavior after laid out ( parasitic, fan out effect etc).

 Please advice.

Thanks in advance.

 

Regards,

hon cheong

 

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.