Stats

Locked Locked
Replies 2
Subscribers 125
Views 14587
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

default simulation states when using ADE-L

Each time I start an ADE-L session, I get a set of default simulation settings automatically loaded. These are taken from one simulation setup which I had once made, and are automatically used as default for some reason, even though I never specified those as my default conditions.

For instance, I get a "tran" analysis which I always have to modify. Why does ADE-L "know" that this is a default state it ought to load each time? How can I get rid of this?

Thanks,
Vivek

Parents

vivkr over 14 years ago

OK! I do see all those ghosts of the past tucked away in that .cdsenv. I will have to edit out those, as I do use the .cdsenv to save some settings, mainly for layout.
Thanks,
Vivek
Cancel
Vote Up 0 Vote Down

Cancel

Reply

vivkr over 14 years ago

OK! I do see all those ghosts of the past tucked away in that .cdsenv. I will have to edit out those, as I do use the .cdsenv to save some settings, mainly for layout.
Thanks,
Vivek
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.