Stats

Locked Locked
Replies 2
Subscribers 125
Views 13020
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

APS: AC during TRAN option ignored

I wanted to run AC analysis at various time instants during my TRAN analysis. So I setup an AC analysis, and in the TRAN options,I selected "actimes = t1 t2 t3 ...", and "acnames = ac". However, the simulation log shows me that no AC analysis was done at any of the specified timepoints, but only once as a separate analysis. Do I need to specify something else in addition?

Thanks,

Vivek

Parents

Andrew Beckett over 14 years ago

Hi Vivek,
My guess is that you're using MMSIM72? Not all analyses were supported in APS mode in MMSIM72. If I use MMSIM72, I see the problem you're seeing, but it works correctly in MMSIM101.
So please try MMSIM101 instead.
Best Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 14 years ago

Hi Vivek,
My guess is that you're using MMSIM72? Not all analyses were supported in APS mode in MMSIM72. If I use MMSIM72, I see the problem you're seeing, but it works correctly in MMSIM101.
So please try MMSIM101 instead.
Best Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.