Stats

Locked Locked
Replies 5
Subscribers 126
Views 13966
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Spaced-based router

Automatic routing is producing many DRC errors by not aligning wires with pins and/or vias. I've tried every routing setting/technology file constraint to prevent this but am at a loss. Any ideas? Thanks, Brian

Parents

Quek over 14 years ago

Would you please try to add minEdgeAdjacentLength and see if it resolves the problem? If you already have this constraint in the techfile, then it might be good to see if VSR615 makes a difference.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Quek over 14 years ago

Would you please try to add minEdgeAdjacentLength and see if it resolves the problem? If you already have this constraint in the techfile, then it might be good to see if VSR615 makes a difference.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.