Stats

Locked Locked
Replies 2
Subscribers 125
Views 13129
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

leHiMarkNet check if net is already marked

Hi, i like to add a bindkey for 1) marking a net. 2) If the net is already marked, it should remove the highlight and 3 if I call the bindkey again it should start at 1) How can I find out, whether the net is already marked. leHiMarkNet reports to the CIW, but there is no return value of the procedure, to evaluate step 2) Bye Erich

Parents

CadSolution over 10 years ago

Hi Erich , Lawrence,

I know this thread is 4 years old but just I run into the same issue and I found that I can use the routine :

_leIsAnyMarkNetHighLighted(cv)

Regards,

Monster
Cancel
Vote Up 0 Vote Down

Cancel

Reply

CadSolution over 10 years ago

Hi Erich , Lawrence,

I know this thread is 4 years old but just I run into the same issue and I found that I can use the routine :

_leIsAnyMarkNetHighLighted(cv)

Regards,

Monster
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.