Stats

Locked Locked
Replies 27
Subscribers 127
Views 32409
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How transient operating point is calculated in cadence

When performing transient analysis with cadence my input is changing and accordingly its operating point should change but when i see its transient operating point than it only show one region throughout the transient analysis please expalin

Parents

RichardCh over 13 years ago

Andrew

I guess the previous problem is caused by APS because the problem is gone when I switched APS to spectre. I think that the info-captab is not supported by APS.

Thanks for your quick reply.

Richard.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

RichardCh over 13 years ago

Andrew

I guess the previous problem is caused by APS because the problem is gone when I switched APS to spectre. I think that the info-captab is not supported by APS.

Thanks for your quick reply.

Richard.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.