• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. effective length variation after Monte Carlo trial

Stats

  • Locked Locked
  • Replies 6
  • Subscribers 126
  • Views 14876
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

effective length variation after Monte Carlo trial

inessadm
inessadm over 13 years ago

Hi, when I run a Monte Carlo analysis in Cadence Spectre-v 6.1.3 (process only), I'm looking for the variation effect
on each nominal length (L effective) of the circuit's transistors.  I find only the varied process data corresponding to
a particular run but nothing about width or length chosen for a trial !
Is there any way to do this please ?
Another question : what the meaning of process data as wd108, wd015, and so on ?
Thank you.

  • Cancel
Parents
  • Quek
    Quek over 13 years ago
    Hi inessadm

    You can print the actual values of the statistical parameters as follows:
    a. In ADE-XL results tab, switch to "Detail" view
    b. Right mouse click at the value column and select "Print Statistical Parameters"

    I am afraid that it is a little hard to guess what "wd108" means. Perhaps you might want to look in the PDK documentation or provide more details on where they are found (in model file, in spectre netlist, etc). If it is one of the parameters that appear in the statistical section of your model file, then it is simply a parameter that the foundry uses for varying the characteristics of a device during monte carlo. Foundry customer support should be able to provide more info on this.

    Best regards
    Quek
    • adexl.gif
    • View
    • Hide
    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Quek
    Quek over 13 years ago
    Hi inessadm

    You can print the actual values of the statistical parameters as follows:
    a. In ADE-XL results tab, switch to "Detail" view
    b. Right mouse click at the value column and select "Print Statistical Parameters"

    I am afraid that it is a little hard to guess what "wd108" means. Perhaps you might want to look in the PDK documentation or provide more details on where they are found (in model file, in spectre netlist, etc). If it is one of the parameters that appear in the statistical section of your model file, then it is simply a parameter that the foundry uses for varying the characteristics of a device during monte carlo. Foundry customer support should be able to provide more info on this.

    Best regards
    Quek
    • adexl.gif
    • View
    • Hide
    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information