Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 13250
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AMS: Grid not seen in Waveforms

medeepak

Hi

I imported a Verilog code for not gate and tried to simulate it by giving a pulse signal as input varying from 0 V to 5 V.

I tried to simulate it using AMS simulator in ADE L

In the output waveform i get doesnth have any value on y axis and the Show Grid button is disabled

 Can anone guide me about to correct this

Thanks in advance

 Regards

deepak

 

 

Parents
  • medeepak

    Hi

     

    I am sorry fr giving less details

    i tried to import a Not Gate verilog in to Virtuoso (IC 6.1.3.1) through the verilog in form

    the not gate code :

     

    module notgate(b,a);

    output b;

    input a;

    assign b =~a;

    endmoudule

    after i imported it i created a schematic cell view with the input of not gate as a pulse voltage source (voltage varying from 0 to 1.8V with rise time 1ns, fall time 1ns, pulse width as 5ns and time perion as 10ns)

    and the output was attached to an output pin

    later i created its config view with AMS template

    in the ADE L window i selected AMS simulator, gpdk.scs as model library ans spectre as solver

    when i do run the ADE i get an output waveform that has no values in its y axis

    my specctre version is 78.2.0

    what could be the possible source of error

    if i had missed any piece of information kindly point it out 

    regards

    deepak

     

     

Reply
  • medeepak

    Hi

     

    I am sorry fr giving less details

    i tried to import a Not Gate verilog in to Virtuoso (IC 6.1.3.1) through the verilog in form

    the not gate code :

     

    module notgate(b,a);

    output b;

    input a;

    assign b =~a;

    endmoudule

    after i imported it i created a schematic cell view with the input of not gate as a pulse voltage source (voltage varying from 0 to 1.8V with rise time 1ns, fall time 1ns, pulse width as 5ns and time perion as 10ns)

    and the output was attached to an output pin

    later i created its config view with AMS template

    in the ADE L window i selected AMS simulator, gpdk.scs as model library ans spectre as solver

    when i do run the ADE i get an output waveform that has no values in its y axis

    my specctre version is 78.2.0

    what could be the possible source of error

    if i had missed any piece of information kindly point it out 

    regards

    deepak

     

     

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.