• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. VCAR V11.2.41.500.6.68 hanging-up on command "route 10"

Stats

  • Locked Locked
  • Replies 3
  • Subscribers 126
  • Views 948
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VCAR V11.2.41.500.6.68 hanging-up on command "route 10"

lawlag02
lawlag02 over 13 years ago

Hi Experts,

Sorry if I am in the wrong forum but I'll ask my question anyway. I wanted to execute Top level routing using vcar but I think the execution stops while at route command "pass 1 0f 10" with no error messages so I am clueless what could be the reason for this.

Before this happened I had a successful run using the same setup and do files.

I hope someone here could have some thoughts on these or experienced the same thing before. many thanks in advance.

best regards,

lrlsk

  • Cancel
Parents
  • lawlag02
    lawlag02 over 13 years ago

     Hi Quek,

    what you said makes perfect sense. we have 6 remote machines dedicated for special tools and top level simulations so I was able to try out on three of them. The first to run the routing a bit more than an hour but on the third one it took only 15mins. So now I am sure that there was not a problem in my do file and constraint file. I am not sure what happened to my local machine because I have run routing on that before with even larger chip, the only thing that was done was changin the keyboard (before I was using Sun keyboard on Dell machine) so I changed the keyboard also to Dell.

    Many thanks again for your insight, it helped me lot.

     BR, lrlsk

     

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • lawlag02
    lawlag02 over 13 years ago

     Hi Quek,

    what you said makes perfect sense. we have 6 remote machines dedicated for special tools and top level simulations so I was able to try out on three of them. The first to run the routing a bit more than an hour but on the third one it took only 15mins. So now I am sure that there was not a problem in my do file and constraint file. I am not sure what happened to my local machine because I have run routing on that before with even larger chip, the only thing that was done was changin the keyboard (before I was using Sun keyboard on Dell machine) so I changed the keyboard also to Dell.

    Many thanks again for your insight, it helped me lot.

     BR, lrlsk

     

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information