Stats

  • Locked Locked
  • Replies 6
  • Subscribers 125
  • Views 17592
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to use Tcl command to get expression value from a AMS simulation?

greatqs

I'm using IRUN for AMS simulation and I'd like to use Tcl commands (i.e. which is used as -input arguments of irun executive) to get expression value a certain waveform (i.e. get ymax value for signal: tb.neta)

 

Could anyone tell me how to do it? Thanks!

 

 

Parents

  • Thanks Andrew, is it possible to use simvision Tcl command interface? 

     

    Andrew Beckett said:

    You can't do it directly. You could use an OCEAN script at the end to get the maximum, or you could write a Verilog-AMS module which followed a waveform and output the maximum, say.

    Andrew.

     

Reply

  • Thanks Andrew, is it possible to use simvision Tcl command interface? 

     

    Andrew Beckett said:

    You can't do it directly. You could use an OCEAN script at the end to get the maximum, or you could write a Verilog-AMS module which followed a waveform and output the maximum, say.

    Andrew.

     

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.