Stats

  • Locked Locked
  • Replies 2
  • Subscribers 126
  • Views 15185
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ncverilog simulation overflow

dzkxybx

hi,

  i am new here. I have a problem as below when i do my design simulation:

 4038444601 Overflow

Simulation stopped via $stop(1) at time 40384446008 PS + 2

how could this happens? thanks!

and my timescale is 1ns/10ps

 

Parents

  • Hi dzkxybx

    From the limited info which you had provided, it is very hard to guess the cause of the problem. If you are not using the latest version of ncverilog, would you please re-try using the latest version and see if the same problem occurs?

    Best regards
    Quek

Reply

  • Hi dzkxybx

    From the limited info which you had provided, it is very hard to guess the cause of the problem. If you are not using the latest version of ncverilog, would you please re-try using the latest version and see if the same problem occurs?

    Best regards
    Quek

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.