Stats

  • Locked Locked
  • Replies 2
  • Subscribers 126
  • Views 13176
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DRC error about laser fuses

bjbit

Hi,

In layout, I drew a shape on layer DV (passivation opening) from technology IBM7RF. The assura DRC reports an error said: "Laser fuses found. Laser fuses are not offered." This rule is not listed in the documents. So I am wondering if this error is critical to the fabrication? Thanks.

Regards, 

Parents

  • Hi Quek,

    Thanks for your reply. It looks strange if DV is not supported but its rules and regarding descriptions are in the tech docs. Hopefully it is the update issue you mentioned. I will ask MOSIS for a clarification.

    Best regards,

    bjbit 

Reply

  • Hi Quek,

    Thanks for your reply. It looks strange if DV is not supported but its rules and regarding descriptions are in the tech docs. Hopefully it is the update issue you mentioned. I will ask MOSIS for a clarification.

    Best regards,

    bjbit 

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.