Stats

  • Locked Locked
  • Replies 3
  • Subscribers 126
  • Views 14780
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Naming output signals in ADE XL

Rowlf

In the Outputs Setup tab of ADE XL (I'm using 6.1.5) it's possible to assign a "name" to an output, whether it's an expression or a signal. But when I click "plot" after the simulation has finished, the traces for expressions are labelled with the name I assigned in the output tab, while the signals are plotted with just their "signal name".

I.e., if I have a signal /I2/in, to which I assign the name "in", and an expression VT("/I2/out") which I've named "out", then in my waveform window I end up with one trace named "/I2/in" and one trace named "out". Is there a way to tell ADE XL to plot signals with their assigned names too?

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.