Stats

  • Locked Locked
  • Replies 4
  • Subscribers 125
  • Views 14499
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to extract parameters in cadence?

usercad

Does anyone know how to extract parameters in cadence IC 6 ?        I use a verilog a model and some parameters in verilog are not shown to the user and I want to know their values?

Parents

  • There would need to be some attributes in the model to assist with saving operating point data if it is a VerilogA model of a compact model. The following forum post and Designer's Guide post (with comments from me) give some guidance on this:

    http://community.cadence.com/cadence_technology_forums/f/38/t/26533

    Regards,

    Andrew.

Reply

  • There would need to be some attributes in the model to assist with saving operating point data if it is a VerilogA model of a compact model. The following forum post and Designer's Guide post (with comments from me) give some guidance on this:

    http://community.cadence.com/cadence_technology_forums/f/38/t/26533

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.