Stats

  • Locked Locked
  • Replies 9
  • Subscribers 126
  • Views 16039
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

EMIR issue (failed to plot resistor)

NovikovBoris

Hi,

    I tyr to use EMIR flow for my design. Made the following steps:

- calibre extraction

- ultrasim simulation for EM/IR database

- use usimEmirUtil for EM/IR report

so..  usimEmirUtil mades me IR report (*.rpt_ir) but can not to plot resistors to EMIR view. I see the following error in the usimEmirUtilOA.emirlog

***ERROR***: failed to plot resistor:rvdd/1410178

and so on for all resistors

DSPF (extracted from layout by calibre) file contains everything: $w,$l,$layer,$X,$Y,$X2,$Y2 as physical paramteres from layout

I do not know where I could miss somthing that EMIR can not to plot resistor at the end.

thnx

Parents

  • Andrew,  

     Problem was in scaled W/L for resistors.. I missed that when made DPSF for EMIR simulation.

    Basically Cadence need to make error message like... "Could not to plot resistors; (resistor width too low)" something like that. I had not scaled resistors in DSPF. DSPF had real sizes (W/L).

Reply

  • Andrew,  

     Problem was in scaled W/L for resistors.. I missed that when made DPSF for EMIR simulation.

    Basically Cadence need to make error message like... "Could not to plot resistors; (resistor width too low)" something like that. I had not scaled resistors in DSPF. DSPF had real sizes (W/L).

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.