Stats

Locked Locked
Replies 1
Subscribers 125
Views 13154
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

values of a cursor messed up

Hi,

I'm using IC 5141. When I add a cursor to any waveform in the waveform viewer, x and y value for the cursor are supposed to show at the lower left section, however, mine got messed up, looks like it's showing some number, but got shifted and overlapped with other numbers/characters etc. I restarted cadence multiple times and it didn't help.

One example of the issues is shown in the link below:

drive.google.com/open

any suggestions?

thanks a lot,

Kevin

Parents

Andrew Beckett over 10 years ago

Kevin,

I've not seen this before. Perhaps you can add a marker rather than the the cursor instead? This is an obsolete version of the software, which is now beyond the final support date (the last hotfix was 3.5 years ago).

Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 10 years ago

Kevin,

I've not seen this before. Perhaps you can add a marker rather than the the cursor instead? This is an obsolete version of the software, which is now beyond the final support date (the last hotfix was 3.5 years ago).

Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.